Sketcher CreateLine/hr

Other languages:
Polyline
Arc by center
Sketcher

Sketcher CreateLine

Menu location
Sketch → Sketcher geometries → Create line
Workbenches
Sketcher
Default shortcut
G L
Introduced in version
-
See also
Sketcher CreatePolyline

Description

The Sketcher CreateLine tool creates a line. introduced in version 1.0: If On-View-Parameters are enabled the tool has three modes.

Usage

See also: Drawing aids.

Pos-OVP = Positional On-View-Parameters. introduced in version 1.0
Dim-OVP = Dimensional On-View-Parameters. introduced in version 1.0

  1. There are several ways to invoke the tool:
    • Press the Create line button.
    • Select the Sketcher → Sketcher geometries → Create line option from the menu.
    • Use the keyboard shortcut: G then L.
  2. The cursor changes to a cross with the current tool mode icon.
  3. If On-View-Parameters are enabled the Line parameters section (introduced in version 1.0) is added at the top of the Sketcher Dialog.
  4. Optionally press the M key or select from the dropdown list in the parameters section to change the tool mode:
    • Point, length, angle: introduced in version 1.0
      1. Pick the start point of the line. Or with Pos-OVP: enter its X and/or Y coordinate.
      2. Pick the endpoint of the line. Or with Dim-OVP: enter the length and/or angle of the line. The angle is relative to the X axis of the sketch.
    • Point, width, height: introduced in version 1.0
      1. Pick the start point of the line. Or with Pos-OVP: enter its X and/or Y coordinate.
      2. Pick the endpoint of the line. Or with Dim-OVP: enter its X and/or Y distance from the start point.
    • 2 points:
      1. Pick the start point of the line. Or with Pos-OVP: enter its X and/or Y coordinate.
      2. Pick the endpoint of the line. Or with Pos-OVP: enter its X and/or Y coordinate.
  5. The line is created and applicable Pos-OVP and Dim-OVP based constraints are added.
  6. If the tool runs in continue mode:
    1. Optionally keep creating lines.
    2. To finish, right-click or press Esc, or start another geometry or constraint creation tool.


Polyline
Arc by center
Sketcher
Sketcher
User documentation