Sketcher CreateSlot/ja

スケッチャー・長円形を作成
メニューの場所
スケッチ → スケッチャージオメトリ → 長円形を作成
ワークベンチ
スケッチャー
デフォルトのショートカット
G S
導入バージョン
-
参照
スケッチャー・円弧状の長円形を作成

概要

The Sketcher CreateSlot tool creates a slot, a closed polyline consisting of two semicircles connected by two parallel straight lines.

使い方

See also: Drawing aids.

Pos-OVP = Positional On-View-Parameters. introduced in 1.0
Dim-OVP = Dimensional On-View-Parameters. introduced in 1.0

1. There are several ways to invoke the tool:
   • Press the Create slot button.
   • Select the Sketcher → Sketcher geometries → Create Slot option from the menu.
   • The keyboard shortcut: G then S.
2. The cursor changes to a cross with the tool icon.
3. Pick the center of the first semicircle. Or with Pos-OVP: enter its X and/or Y coordinate.
4. Pick the center of the second semicircle. Or with Dim-OVP: enter the distance between the centers and/or angle of the slot. The angle is relative to the X axis of the sketch.
5. Pick a point to define the radius of the slot. Or with Dim-OVP: enter this radius.
6. The slot is created and applicable Pos-OVP and Dim-OVP based constraints are added.
7. If the tool runs in continue mode:
   1. Optionally keep creating slots.
   2. To finish, right-click or press Esc, or start another geometry or constraint creation tool.

補足

• 0.21 and below (introduced in 0.20): Holding Ctrl when picking the second center will constrain the slot to be drawn horizontally or vertically.
• introduced in 1.0: Angular snap can be used to control the angle of the slot.
• introduced in 0.20: A slot can also be constrained horizontally or vertically if the Auto constraints option is enabled.